ServicesPatio Doors
Patio Doors in East Tawakoni
We replace sliding, French and hinged patio doors with units sized to your opening, tempered glass in every panel and a sill that is flashed and sealed before the trim goes on. You get a door that glides, locks and passes inspection, with a clear written quote first.

A big opening with real rules
Of all the glass in your home, the patio door is usually the biggest panel that moves, and building codes treat it with care. Each pane has to be safety glass, the opening needs a sound header overhead, and the sill must send water outward rather than toward the floor. When an older slider sticks, leaks or fogs, one of those details has usually slipped.
We take out the old unit, check the framing and subfloor, and set a new door that is plumb, square and sealed. If your city or county requires a permit for the change, we handle the filing and schedule the inspection, and we explain what the inspector will look at before they arrive.
Our team has over 10 years of experience setting doors like this. We would rather spend an extra hour on the flashing than have you find a damp floor next spring.
What the work includes
Sliding, French or hinged styles
We install two- and three-panel sliders, French doors that swing in or out, and hinged doors with fixed side panels. Frames come in vinyl, fiberglass or aluminum-clad wood, each with its own look and upkeep. We bring samples to the consultation so you can see the finish and feel the hardware.
Tempered, low-E glass
Every panel is tempered safety glass, marked in the corner as code requires. Low-E coatings cut the heat that pours through a large pane on a summer afternoon, and argon-filled units help the door meet the energy code.
Sill pan and flashing
Before the door goes in, we set a sloped sill pan and tape the rough opening so any water that gets past the weatherstrip drains out, not into your subfloor.
Framing check and repair
With the old door out, we inspect the header, studs and subfloor. If we find soft wood, we show you photos and add it as a written line item before replacing it.
Hardware, screens and adjustment
Multi-point locks, keyed handles and screens are fitted and adjusted so the door rolls or swings without force and latches on the first try.
Trim, caulk and cleanup
We finish the trim inside and out, seal the perimeter, haul away the old door and vacuum where we worked.
When a patio door has reached its end
Hard to slide, or off its track
If opening the panel takes both hands, the rollers are likely worn and riding on a track that is bent or pitted. Fresh rollers on a damaged track seldom hold up for long.
A haze you cannot wipe away
When the glass looks cloudy from the inside of the unit, the seal around the insulated glass has broken and damp air has crept in. The panel no longer insulates the way it should, and cleaning will not clear it.
Water on the floor after storms
Spring storms in North Texas can drive rain sideways against the back of the house. If the floor near the door is damp afterward, the sill or flashing is failing, and the subfloor may already be soft.
Gaps you can see or feel
Daylight around the edges or a draft on a windy day points to a frame that has racked out of square or weatherstrip that has flattened.
No tempered mark on the glass
Some older doors have plain annealed glass, which breaks into sharp shards. If you cannot find the small etched mark in a corner, replacing the door is worth it for safety alone.
A lock that will not line up
When the latch only catches if you lift or push the panel, the door has settled out of alignment and is not secure.
How a patio door job runs
- 1
Free in-person consultation
We measure the opening, look at the framing from inside and out, and talk through styles, glass and hardware. You receive a written line-item estimate that notes any inspection the job will need.
- 2
Ordering and paperwork
Patio doors are built to size, so we order once you approve the estimate. While the door is being made, we confirm with the building department whether a permit applies and file it when it does.
- 3
Installation day
Most single doors are set in one day. We lay drop cloths, remove the old unit, repair any framing we documented, install the sill pan, then set the door plumb and square and seal it. Your home is closed and locked before we leave.
- 4
Inspection and walkthrough
If an inspection is required, we meet the inspector and tell you what was checked. We also show you how to clean the track and adjust the lock, and answer anything still on your mind.
What drives patio door pricing
Patio door costs vary more than many homeowners expect, mostly because of size, glass and the condition under the old sill. We never quote a door from a picture. After your consultation, you get a written estimate with every part of the work on a separate line. To spread the cost, ask about our 0% Financing options, and there is also $0 Down on the whole project.
- How wide, and how many panels
- The basic setup is two panels, one fixed and one sliding. Three- or four-panel units and French door pairs use more glass and heavier hardware, so they cost more.
- Which frame you choose
- Vinyl costs the least and asks little upkeep. Fiberglass stays true in the heat and paints well, and aluminum-clad wood pairs a wood interior with an easy-care outside at a higher price.
- Glass and hardware upgrades
- Low-E coatings, blinds built in between the panes, multi-point locks and nicer handle finishes all raise the total.
- What is under the old door
- A rotted subfloor or sagging header means more labor and materials. You see photos before that repair is added to the estimate.
- Resizing the opening
- Converting a window to a door or making an opening wider calls for new structural framing and a review by the building department, so it takes longer than a same-size swap.
Questions about patio doors
Something not covered here? (903) 420-4585
Is a permit needed for a new patio door?
That depends on your location and what the job involves. Swapping a door for one the same size usually takes less paperwork than widening the opening or putting a door where a window was, since those alter the structure. We ask the building department about your address and file anything required.
Should I go with a slider or French doors?
Sliders leave the floor open since the panels pass one another rather than swinging, which works well on a small patio or in a crowded dining space. French doors open wider and look more classic but need clearance to swing. At your consultation we consider how the room gets used and help you decide.
Will the opening be exposed for long?
Typically just part of a day. The old door stays in until the new one has arrived and been inspected, and we seal and lock the opening before we go.
Will my patio door match new windows?
It can. When window replacement is also on your list, we match the frame color, grids and glass so the back of the home looks uniform. Some homeowners replace their entry doors at the same time for that reason.
How can I tell your work lasts?
Our company holds an A+ rating from the Better Business Bureau. During the consultation we can show you how we flash a sill and what we look over before a door is done. Ask about any material or code question and we will answer directly.

Let us look at your patio door opening
We will measure, check the framing and explain what the inspector will want before you commit to anything. We serve East Tawakoni and nearby towns such as Greenville and Wills Point.